GS-RH - Rod Holder Adapters Mounting Option
Easy to install
GS-RH for 1-1/2" diameter rod holders
Simply slip into the rod holder and tighten top wing nut until the adapter is tight and immovable. The slip design makes this a very versatile mounting option for your Gullsweep®.
Many rod holders are set at an angle to the hull to support a rod (some as much as 45°). The stainless steel support bracket for the Gullsweep® mounting pin has two side notches so you can bend it to the desired angle. Best to put mounting pin in place and then bend bracket. Make sure the Gullsweep® center pin is set (or bent) so the pin will be vertical to the water.
Mount your Gullsweep® on the pin and be sure it will clear all obstacles when rotating.
To remove, loosen the screw and pull out of rod holder.